PRECISION INSUL.STRIPPERS

• Form-fit stripping of difficult-to-remove insulating materials made of PTFE, silicone, Radox®, Kapton® and rubber; multi-layer too
• A second pair of blades holds the remaining insulation reliably in place
• Replaceable shaped blade adapted precisely to the respective conductor cross-section
• With length stop for constant stripping length during repetitive work
• Especially for cables in accordance with the American specification (AWG)

Technical attributes

Article No.

12 12 13

EAN

4003773077534

Pliers

burnished

Handles

with multi-component grips

Weight

450 g

Dimensions

195 x 107 x 33 mm

REACH compliant

contains SVHC

RoHS compliant

not applicable

AWG

10 / 12 / 14 / 16 / 18 / 20

Precision wire strippers for special insulation materials (AWG)

Two pairs of blades: division of labour for the desired result

The Knipex 12 12 13 wire strippers have been specially developed for very tough and hard insulation materials which need to almost be cut through entirely so that they can be pulled off. Two pairs of blades cut into the entire circumference of the cable insulation. The blades have been shaped and ground so that the cut gets very close to the conductor. After scoring, one of the pairs of blades remains still and secures the insulation that has been cut into. The other pair of blades strips the insulation from the cable.

Length stop for reproducible stripping results

The precision wire strippers have a length stop for consistent wire stripping results, which can be easily pushed together with your fingers to slide and adjust it. This enables wire stripping results to be achieved even in the case of demanding insulation materials, meeting high requirements in terms of consistent quality – also for the US market.

Insert cable, press pliers closed – cable is stripped

The work saved by these wire strippers is immense. After inserting the cable, the entire wire stripping process takes place as if by itself with one press of the hand. Even insulation materials that are difficult to process are reliably removed with precise and, thanks to the length stop, accurate repeat measurements: an advantage for fitters who use cable corresponding to the American specification AWG (10, 12, 14, 16, 18, 20) in the areas of energy technology, plant and automotive engineering.

Brief overview

Two pairs of blades cut parallel into the insulation, and remove it with a separating movement

Specially for cables in accordance with American specifications

AWG (American Wire Gauge): 10, 12, 14, 16, 18, 20

Handles with multi-component grips

Length stop easily set by pressing together and sliding for accurately repeated wire stripping

Spare set of blade available

Net weight 450 g