Individual Punches
This category holds punches sold one at a time, for replacing a lost or worn punch from a set, adding a size you use often, or buying a special punch for one job. It covers pin punches, center punches, pilot and drift punches, hollow punches and pneumatic punches for air hammers, in fractional and metric sizes. Auto repair technicians, body shops, fleet shops, machinists and industrial maintenance crews all use them. For complete sets, see the punch Sets category.
Choosing the right punch
Pin punches have a straight shank and flat tip for driving roll pins, spring pins and straight pins all the way out. Drift and starter punches have a tapered shank and are used to start a stuck pin or line up parts. Pilot punches line up holes in two parts so a bolt can go through. Center punches have a sharp point that marks a starting spot so a drill bit does not wander. Hollow punches cut round holes in gaskets, leather, rubber and sheet material. Pneumatic punches fit an air hammer for heavy or repeated work.
Sizing and use
Match the punch tip to the pin: a punch much smaller than the pin can bend or mushroom the pin end, and one larger than the hole will jam. Start a tight pin with a starter punch, then finish with a pin punch. Strike squarely with a hammer of suitable weight, and wear eye protection, since a struck punch can throw chips.
Keeping punches in shape
A mushroomed striking end should be ground back, and a bent or chipped punch should be replaced. Some punches have a guard on the shank that keeps the holding hand away from the hammer.
Brands we carry here include Mayhew, Kukko, Williams, SUR&R, SureWerx and Genius, with more from Proto, Ajax and GearWrench.




















































.jpeg)


Follow us on social media