Metric
Metric hex bit sockets for 1/4 in. drive ratchets, sold as individual millimeter sizes and as multi-piece sets.
Similar Categories
Featured Products - Metric
Best Selling Products - Metric
1/4 In Drive Metric Hex Bit Sockets
Metric hex bit sockets combine a 1/4 in. square drive socket with a hex (Allen) bit, so a ratchet, extension or torque wrench can turn internal hex fasteners in millimeter sizes. The small drive suits interior trim, sensors, small engine covers, brackets and other light fasteners where a larger drive will not fit. Auto repair technicians, motorcycle and small engine mechanics and industrial maintenance crews use them every day on metric hardware.
Individual sizes or a set
This category splits into two subcategories. Individual holds single sockets in one mm size, for replacing a lost or worn bit or adding a size you use often. Sets hold a run of common sizes on a rail or in a case, which is the easier way to start or to keep a matched group in one drawer.
Using them well
A bit socket turns a hex key job into a ratchet job, which is faster and gives better control on a fastener that needs to be snugged to a value. Seat the bit fully in the fastener before turning; a hex bit that sits half in will round out the socket head of the screw. Do not mix up metric and SAE sizes, since some are close enough to feel like they fit and still strip the fastener. Replace bits once the corners wear.
Brands here include SK, Titan, Genius, VIM, Williams and NEPROS. SAE hex bit sockets and Torx bit sockets for the same drive size are in the SAE and Torx categories next to this one.
















Follow us on social media