Aviation Snips and Snip Sets
Aviation snips are compound-leverage hand shears for cutting sheet metal. A linkage between the handles and the blades multiplies hand force, so they cut thin steel, aluminum and other sheet stock with far less effort than plain tin snips. This category holds individual snips and 3 piece sets with one of each cut.
Left, right and straight cut
Handle colors usually mark the cut. Left cut snips curve to the left and right cut snips curve to the right, so the waste strip curls away from the blades and the hand. Straight cut snips make straight lines and wide curves in either direction. A 3 piece set with all three covers most layout work. Offset snips set the handles above the blades so the hand stays clear of the sheet on long cuts.
Using them
Cut with the full length of the blade and keep the jaws square to the sheet for a clean edge. Wear gloves, since cut sheet metal edges are sharp. Snips are made for sheet stock, not wire, bolts or hardened parts, which can nick the blades.
Body shops, HVAC and duct installers, fabricators and maintenance crews use aviation snips for trimming panels, heat shields, flashing and ductwork. Brands we carry here include Williams, Irwin, Knipex, Channellock, Crescent and Milwaukee. Wire and cable cutters are in Cable Cutters, and cutters for bolts and chain are in Bolt Cutter.























































Follow us on social media