Outside Micrometers
A micrometer measures thickness or outside diameter by closing a precise screw spindle against the part until it is held lightly between the anvil and spindle. It reads finer than a caliper and is the standard tool for checking crankshaft journals, valve stems, pistons, shafts and shims. This category holds outside micrometers in conventional and digit counter styles and micrometer sets that cover several ranges. Engine builders, machine shops, inspection departments and maintenance mechanics use them.
Choosing the right type
Each outside micrometer covers a one inch range, such as 2-3 in. or 5-6 in., so measuring larger parts takes a larger frame. Sets put several ranges in one case, with setting standards for checking zero on the larger sizes. Conventional micrometers are read from the scales on the sleeve and thimble, commonly in .001 in. graduations. Digit counter models add a mechanical counter that shows the reading in numbers for faster, easier reading.
Using them
Clean the anvil, spindle and part before measuring, and check zero with the standard. Use the ratchet stop or friction thimble so every reading is taken with the same light pressure. Hold the frame by its insulated pad when you can, since heat from your hand can change the reading. Measure a journal in more than one spot and direction to find taper and out of round.
Care
Store a micrometer with the faces slightly apart, wipe it down after use and keep it in its case. Check it against the standard on a regular schedule, and have it calibrated if it will not zero. A dropped micrometer should be checked before it is trusted again. Calipers, dial indicators and bore gauges are in Dial Calipers, Dial Indicators and Cylinder Bore Gauges.
Brands here include Fowler, Central Tools, NEPROS and General Tools.





























Follow us on social media