SAE Striking and Slugging Wrenches
Striking wrenches, also called slugging wrenches, are short, heavy box end wrenches with a striking face on the end of the handle. The wrench is set on the nut and struck with a sledge or hammer to break loose or tighten large fasteners that a normal wrench cannot turn. This category holds inch sizes in straight and offset patterns, mostly with 12 point box ends.
Straight or offset
Straight pattern wrenches keep the head in line with the handle and work where the nut sits on a flat surface with room around it. Offset wrenches angle the head away from the handle, which lifts the striking face clear of a flange or housing so the hammer can land square without hitting the work. A 12 point box fits onto the nut in more positions, which matters on crowded flanges where the handle has only a few places to sit.
Sizes
Sizes are listed by the wrench opening across the flats of the nut, such as 1-1/8 in. or 1-3/8 in., so match the opening to the nut, not to the bolt diameter.
Using a striking wrench
Seat the box fully on the nut, make sure the wrench cannot slip, and strike the face squarely with a hammer of suitable weight. Glancing blows can make the wrench jump off the fastener. Check the striking face and box for mushrooming and cracks, and retire a wrench that shows them.
Where they are used
Striking wrenches are used in industrial maintenance, refineries and pipelines, power plants, mining, heavy equipment and fleet shops, on flange bolts, large machinery nuts and other big fasteners. Metric striking wrenches are in the Metric category next to this one.
Never use a standard combination or box end wrench as a striking wrench, since it is not made to be hit.
Brands we carry here include Williams, Martin and Proto.










































Follow us on social media