Punch Sets and Stamp Sets
A punch set keeps several sizes of one punch type, or a mix of types, together in a pouch, stand or case so the right size is close at hand. This category holds pin and pilot punch sets, center punch sets, punch type swaging tools, letter and number stamp sets, and replacement punches for ring and hole punching tools. Single punches are in the sibling Individual category under Punches.
Choosing the right type
Pin punches have a straight shank of even diameter and drive roll pins, spring pins and dowels out of a bore once they are moving. Pilot punches, also called alignment or drift punches, have a long taper and are used to line up the holes in two parts so a bolt can be fitted. Center punches leave a small dimple that keeps a drill bit from wandering when a hole is started. Swaging punches stretch the end of soft tubing so another tube can slide inside it. Letter and number stamps mark characters into metal parts, tags and tools for identification.
Replacement punches
A large share of this category is replacement punches for Kukko ring punching tools and similar hole punches, which cut clean round holes in soft materials such as gasket stock, leather and plastic. Match the tool model and punch size before ordering a replacement.
Using them
Pick a pin punch close to the pin diameter so it does not spread the pin or jam in the bore, and keep the punch square to the work. Dress or replace punches with mushroomed heads or bent tips. Stamps give the cleanest marks with one firm blow per character on a solid surface, and a guide or straight edge keeps a line of characters even.
Machinists, fabricators, auto repair technicians and industrial maintenance crews use punch sets for disassembly, alignment and part marking. Brands we carry here include Kukko, Mayhew, Williams, Wright Tool, C.H. Hanson and ATD, with Knipex and Woodward Fab also in the range.


























































Follow us on social media