Individual Metric Box End Wrenches
A box end wrench closes fully around a nut or bolt head, so it grips on all sides instead of on two flats like an open end wrench. This category holds metric box end wrenches sold one size at a time, mostly double box and offset ring wrenches with a different size on each end. It is the place to replace a lost or worn size, or to add a size your set never had. Auto and truck technicians, industrial maintenance crews and machine shops all keep a run of these on hand.
Choosing the right type
Double box wrenches put two sizes on one tool, such as 10 x 11mm, so one wrench covers two common fasteners. Offset ring wrenches angle the box away from the handle, which lifts your knuckles clear of the work surface and helps reach fasteners that sit below nearby parts. Many box ends are 12 point, which lets the wrench seat in more positions and suits tight spots where the handle can only swing a short arc. A 6 point box grips the flats rather than the corners and is the better pick on stubborn or slightly rounded fasteners.
Sizes and fit
Every wrench here is metric, sized in millimeters across the flats. Use the exact size the fastener calls for; an SAE wrench that seems close will slip and round the corners. Sizes run from small wrenches for trim and electrical work up to large ones for heavy equipment and industrial fasteners.
Using them
Seat the box fully on the head before pulling, and pull toward you rather than pushing when you can. Use a box end to break a tight fastener loose, then switch to a ratchet to spin it off. Never add a cheater bar to a standard box wrench or strike it with a hammer; striking wrenches are made for that job.
Brands here include Bahco, Williams, Genius, Beta, NEPROS and Stahlwille. Matched metric sets are in the Sets category next to this one.












































Follow us on social media