1/4 In Drive SAE Bit Sockets, Individual
Bit sockets pair a 1/4 in. square drive socket with a bit, so a ratchet, extension or torque wrench can turn screws and internal drive fasteners. This category holds single pieces in SAE (inch) sizes, sold one at a time, including fractional hex bit sockets and replacement slotted screwdriver bits for bit sockets. Auto repair technicians, small engine mechanics, aviation and industrial maintenance crews buy individual sizes to replace a worn bit or add a size a set does not include.
Reading the sizes
Hex bit sockets are sized by the fractional inch measurement across the flats of the hex. Slotted screwdriver bits are sized by two numbers: the blade thickness, given in thousandths of an inch, and the blade width, given as a fraction. A bit listed as .040 in. x 1/4 in., for example, has a blade that thick and that wide. Matching both numbers to the screw slot gives a bit that fills the slot and will not twist out.
Using bit sockets
A bit socket turns a screwdriver or hex key job into a ratchet job, which gives more control and lets you check torque with a torque wrench. Push the bit fully into the fastener before turning. Where the bit is replaceable, swap it once the edges are rounded or chipped rather than replacing the whole socket.
Brands here include SK, Titan, Williams, Grey Pneumatic, Sunex and Assenmacher. Complete SAE bit socket sets are in Sets under the SAE category, and metric sizes are in the Metric category for the same drive.













































Follow us on social media