Individual 1/2 In. Drive SAE Crowfoot Wrenches
A crowfoot wrench is an open end or flare nut wrench head with a square drive hole instead of a handle. It snaps onto a ratchet, extension or torque wrench so a nut can be turned where a socket cannot slide over it, such as on a tube nut, a fitting on a line, or a large nut tucked behind a housing. This category holds single 1/2 in. drive crowfoot wrenches in inch sizes, from around 1-1/4 in. up to large sizes such as 1-7/8 in., 2 in. and 2-3/8 in. Industrial maintenance crews, heavy equipment and diesel mechanics and hydraulic service technicians are the main users.
Why the 1/2 in. drive
Larger nuts need more turning force than a 3/8 in. drive can carry. The 1/2 in. drive suits these bigger heads and pairs with common 1/2 in. ratchets, breaker bars and torque wrenches. Some heads here are sold as jumbo sizes for very large fittings and nuts.
Using a crowfoot with a torque wrench
A crowfoot moves the point where the force is applied away from the end of the torque wrench. When the crowfoot is set in line with the handle, the reading changes and the setting has to be corrected for the added length. When the crowfoot is turned 90 degrees to the handle, the effective length barely changes and most users treat the reading as direct. Follow the torque wrench maker's instructions for the correct method.
Choosing and care
Pick the exact inch size and check the clearance around the nut, since the head must slide on from the side. Seat the jaws fully on the flats before pulling, and keep the drive hole clean so it locks onto the drive tang.
Brands we carry here include Williams, Martin, Sunex, Proto and V8 Tools. Smaller sizes are in the 3/8 in. drive SAE crowfoot category alongside this one.
































.jpeg)





Follow us on social media