Free shipping on orders overFree shipping over $250 Lower 48 states and DC. Excludes freight and oversize.

Metric Crowfoot Wrenches

Individual metric crowfoot wrenches and crowfoot sets, open end and flare nut, for 3/8 in. and 1/2 in. drive tools.

Best Selling Products - Metric Crowfoot Wrenches

Metric Crowfoot Wrenches

A crowfoot wrench is a wrench head with a square drive hole, so it fits on a ratchet, extension or torque wrench. It reaches nuts where a socket cannot slide over the fastener, such as brake, fuel, A/C and hydraulic line fittings, and nuts tucked behind other parts. This category has two subcategories: Metric Ind. Crowfoot Wrenches, single open end and flare nut heads in 3/8 in. and 1/2 in. drive, including jumbo sizes over 40 mm, and Metric Crowfoot Wrench Sets, with sets from about 10 to 17 pieces.

Open end or flare nut

An open end crowfoot slips onto a nut from the side and suits general fasteners. A flare nut crowfoot wraps around more of the nut, leaving only a narrow gap for the line, so it grips soft tube nuts on more sides and is less likely to round them off.

Using a crowfoot with a torque wrench

Because the crowfoot head sits in front of the drive, it adds length to a torque wrench. Mounting the crowfoot at a right angle to the wrench handle keeps the reading the same as the setting; mounted in line, the torque at the nut is higher than the wrench shows unless it is corrected.

Auto repair technicians, fleet and diesel shops and industrial maintenance crews use crowfoot wrenches on line fittings and hard-to-reach nuts. Brands we carry here include Williams, V8 Tools, Proto, Sunex, K Tool and GearWrench. Inch sizes are in SAE Crowfoot Wrenches.