Sledge and Engineer Hammers
When a ball peen hammer is not enough, a sledge or engineer hammer brings the weight. These hammers deliver heavy blows to free seized parts, drive pins, shafts and stakes, set parts into place and break tire beads. Sledge hammers have a large double-face or cross pattern head on a long handle for two-handed swings, while engineer hammers, also called drilling hammers, are shorter heavy hammers used with one hand. This category includes steel and brass head hammers in head weights from a few pounds up to 10 lb, with wood, fiberglass and steel handles, plus tire hammers. Fleet and diesel shops, tire shops, farm and heavy equipment mechanics and industrial maintenance crews all use them.
Choosing the right type
Double-face sledges strike with either end and are the general-purpose choice. Cross pattern sledges have a wedge-shaped face on one side for splitting and shaping. Engineer hammers give control in tight places where a long handle cannot swing. Brass heads are softer than steel and are used where a steel hammer would mark or damage a part or shaft end.
Head weight and handle
A heavier head moves more with each blow but tires the user sooner; pick the lightest hammer that does the job. Longer handles add swing speed and force, and shorter ones add control. Wood handles absorb some shock, fiberglass handles resist weather and wear, and steel handles stand up to hard use.
Using them
Wear safety glasses, check that the head is tight on the handle and that the face is not chipped or mushroomed, and strike with the face square to the work. Never strike one hardened hammer face against another. Ball peen, dead blow, soft face and brass hammers are in the sibling categories under Hammers.
Brands we carry
Sledge and engineer hammers here come from Wilton, Williams, Wright Tool, Ken-Tool, Bahco and Vaughan, with more from Proto, Titan and Martin.
















































Follow us on social media