1/4 In. Drive SAE Sockets
1/4 in. drive sockets are the smallest common drive size, used on small fasteners where light torque and a compact ratchet head fit best. This category holds individual SAE (fractional inch) sockets in standard and deep lengths, with 6 point and 12 point openings. Single sockets let a technician replace a lost size, add a deep version of a size, or carry only the sizes a job needs. Auto repair technicians use them on interior trim, dash, sensor and small engine fasteners, and they are also common in electronics, small engine, aviation and equipment repair.
6 point or 12 point
A 6 point socket grips the flats of a hex nut or bolt head and is less likely to round off a tight, rusty or worn fastener, so it is the usual choice for breaking fasteners loose. A 12 point socket fits onto the fastener in twice as many positions, which helps when the ratchet has little room to swing or the socket must be placed at an awkward angle. Twelve point sockets also fit 12 point fasteners found on some equipment.
Standard, mid-length or deep
Standard length sockets keep the ratchet close to the work for the most clearance overhead. Mid-length and deep sockets reach nuts on long studs and bolts that stick out past the nut, and they reach fasteners set down in a recess. Many technicians carry both lengths in the most used sizes.
Using 1/4 in. drive tools
The small drive is made for light torque. For fasteners that need more force, step up to 3/8 in. drive rather than adding a cheater bar. Hand sockets are not built for impact wrenches; use impact-rated sockets with power tools.
Brands we carry here include NEPROS, Williams, SK, GearWrench, Milwaukee and K Tool. Metric sizes are in 1/4 in Drive metric sockets, and sets are in 1/4 In Drive SAE Socket Sets.






































.jpeg)









Follow us on social media