Rocker Panel Coating, 23 ounce, Grey 8889
3M™ Rocker Panel Coating 08889 is a resilient coating
designed to protect lower auto body panels from damage such as stone
chipping. This coating is applied over primer coated panels and under
top coats providing an additional layer of protection to the substrate.
3M™ Rocker Panel Coating 08889 is compatible with common
automotive paints.
3M™ Rocker Panel Coating 08889 produces a textured finish
which resists chipping, abrasion, rusting and weathering. Specifically
developed to match OEM medium to coarse textures and produces a
resilient under-the-paint coating to protect your vehicle year after
year. Ideal for use on rocker panels, under bumpers and under-carriages
to prevent exterior corrosion. 3M™ Rocker Panel Coating 08889
is fast drying, paintable, and offers excellent sound deadening
properties. VOC Compliant in all 50 states.
DIRECTIONS FOR USE
Surface Preparation
Prime all bare metal surfaces with urethane or epoxy primer. Sand the
primer using grade P320 - P500, clean the surface and mask accordingly.
NOTE 1: When repairing into factory applied chip guard coatings prime
the sanded factory coating with epoxy primer to prevent
“lifting” or “blistering”.
NOTE 2: Apply only to surfaces primed with a 2K urethane, 2K epoxy
primer, or clean, sanded paint. Acid etch primers should never be in
direct contact with the coating.
Application And Sanding
Use at temperatures above 65°F (19°C), shake until
agitator ball moves freely in the can.
Apply a light even coat to the surface from a distance of 10 - 12
inches (25 - 30 cm). Allow 5 minutes dry time before applying
additional coats.
Apply additional coats to match desired texture, allowing adequate dry
time between coats to avoid solvent bubbling. Texture can be varied by
adjusting application speed, distance, and coating thickness. For best
results, invert the can and spray to clear the actuator between coats
and after use.
Finishing
Allow 1 hour dry time when 2 coats are applied (more dry time is needed
if additional coats have been applied) prior to painting. Lightly scuff
sand using grade P500 - P600 abrasive and apply top coats or
primer/sealer (refer to paint manufacturers guidelines for paint
application information).
VOC Information
VOC Compliant in all 50 states.
Please consult state and local regulations. CARB Category: Automotive
Bumper and Trim Product. VOC Limit = 1.75 g O3/g product. This product:
1.63 g O3/g product.
Additional Product Information
3M Part Number
8889
UPC
51135088890
Case Inner Pack
1 aerosol can
Brand
3M
Application
Rocker Panel Coating
Texture
Medium
Paintable
Yes
Paint Time
2 Hours
Dry Time
2 Hours
Color
Grey
3M
Automotive 8889 Rocker Panel Coating, 23 ounce,
Grey
Follow us on social media