O-Rings and Replacement Seals
O-rings are round rubber seals that sit in a groove and stop air, oil, grease, paint or refrigerant from leaking past a joint. When an air tool, grease gun, paint gun or tire machine starts to leak or lose power, a worn o-ring is often the cause, and replacing it costs far less than replacing the tool. This category holds replacement o-rings, packing o-rings such as Buna-N packings, L rings and similar seals sold as service parts for tools and shop equipment.
Finding the right part
Most items here are listed under the part number of a specific tool or machine, so the surest way to order is to find the parts list or exploded view for your model and match the part number. Size alone can mislead: two o-rings can look alike but differ in cross section, inside diameter or rubber compound, and a compound that suits air or oil may not suit solvents or refrigerant. When a tool needs several seals, a rebuild kit for that model, where one is offered, saves ordering them one at a time.
Fitting o-rings
Clean the groove and the mating surfaces, and check for nicks or burrs that would cut the new seal. Lightly lubricate the o-ring with a lubricant that suits the fluid it will seal, roll it into place rather than dragging it over sharp threads or edges, and make sure it is not twisted in the groove. When rebuilding a tool, replace all of its seals together so an old one does not cause the next leak.
Tool repair shops, tire shops, fleet shops and industrial maintenance crews use these parts to keep tools and equipment in service. Washers, snap rings, springs and other hardware are in the sibling categories under Hardware. Brands we carry here include haltec, Esco, Lisle, FJC, Astro Pneumatic and Sunex, along with service parts from Milwaukee, OTC and Graco.




























































Follow us on social media