Flex Hones and Cylinder Hones
A hone is an abrasive tool turned in a drill to finish the inside of a bore. The flexible hones in this category, often called ball hones, carry small abrasive globules on flexible filaments. Because the filaments flex, the hone follows the existing bore instead of cutting a new one, and it leaves an even crosshatch finish.
How they are used
The most common job is deglazing an engine cylinder before new rings go in, so the rings can seat. Flex hones also remove light scoring, rust and varnish and deburr cross-drilled holes and ports. In use, the hone is lubricated with honing oil, spun in a drill and stroked in and out of the bore at a steady pace; the stroke speed sets the crosshatch angle. The bore is then cleaned thoroughly to remove abrasive and metal particles.
Choosing size and grit
Flex hones are sized to the bore diameter, in inch and metric sizes, and the hone should be slightly larger than the bore so the filaments press on the wall. Grit sets the finish: coarser grits remove more material, finer grits leave a smoother surface. Engine rebuilders, machine shops, auto repair technicians and industrial maintenance shops use them on engine, compressor and hydraulic cylinders. Grinding stones, burrs and wire brushes are in nearby Abrasives and Grinding categories.
Brands we carry here include Brush Research, Old Forge and CTA.





































Follow us on social media