Harmonic Balancer Tools
The harmonic balancer, or crankshaft damper, is pressed onto the front of the crankshaft and drives the accessory belt. It has to come off for timing belt, timing chain and front crank seal work, and is often replaced when its rubber layer fails. Because it is a press fit, prying or hammering on it can damage the balancer, the crank snout or the engine bearings. The tools in this category take it off and hold it safely.
Pullers and holders
A balancer puller bolts to threaded holes in the balancer hub. Its center forcing screw pushes against the end of the crankshaft and draws the balancer straight off evenly. Use an adapter or protector on the crank snout so the screw does not damage the center bolt threads. Holding tools lock the balancer or crank sprocket so it does not turn while the large center bolt is loosened or torqued, which can be very tight. This category also holds engine-specific pullers and holders and replacement push rods and parts for pullers you already own.
What to look for
Check that the puller bolt pattern and bolt threads fit the balancer, and that the forcing screw reaches the crank. A matching installer presses the new balancer on evenly; never hammer one onto the crank.
Auto repair technicians, engine builders and fleet shops are the main users. Brands here include Lisle, OTC, Schley, Cal-Van, Great Neck and CTA. Timing, camshaft and belt tensioning tools are in the sibling Engine Repair categories.
























































Follow us on social media