Snap Rings and Retaining Rings
Snap rings, also called retaining rings or circlips, are spring steel rings that sit in a groove on a shaft or inside a bore to stop bearings, gears, pins, pulleys and other parts from sliding out of place. They are found in axles, transmissions, steering columns, pumps, motors and power tools, and a damaged or lost ring has to be replaced before the part goes back together. This category includes internal and external snap rings, E-rings and C-clips, snap ring replacement kits and assortments in a storage case, along with spring pins and related retaining hardware. Auto repair technicians, transmission and drivetrain shops, fleet and equipment mechanics and industrial maintenance crews keep an assortment on hand.
Choosing the right type
External rings expand over a shaft and close into a groove on its outside, while internal rings are squeezed to fit into a bore and spring out into a groove inside it. Rings with lug holes are installed with snap ring pliers. E-rings and C-clips push onto a shaft groove from the side and need no pliers, which makes them common on linkages and small shafts. Match the ring to the shaft or bore diameter and the groove width.
Assortments or single sizes
An assortment in a divided case covers many common sizes and suits shops that see a wide mix of equipment. Single packs make sense when the same ring is replaced often.
Using them
Open or close a ring only as far as needed to fit it, since overstretched rings lose their grip. Make sure the ring snaps fully into its groove, and wear eye protection, as rings can fly when they slip off the pliers. Snap ring pliers are under Pliers, and other shop hardware such as pins, springs, washers and o-rings is in the sibling categories under Hardware.
Brands we carry
Snap rings and assortments here come from Just Clips, Blackhawk, GearWrench, OTC and Lisle.



























































Follow us on social media