Sockets-Engine Special
Specialty sockets for removing and installing oxygen sensors, oil pressure switches and vacuum switches on engines.
Similar Categories
Featured Products - Sockets-Engine Special
Best Selling Products - Sockets-Engine Special
Engine Specialty Sockets
Sensors and switches screwed into an engine often have a wire or connector coming out of the top, so a standard deep socket will not fit over them. Engine specialty sockets have a slot or an open side for the wiring, or a special shape for the sensor body. Auto repair technicians, emission and drivability shops and fleet shops use them when replacing sensors after a check engine light or an oil pressure warning.
Choosing the right type
This category has three subcategories. Oxygen Sensor tools holds slotted and offset oxygen sensor sockets and sensor socket sets; offset and crowfoot-style designs reach sensors tucked against an exhaust pipe or manifold. Oil Pressure-Stop Switch holds sockets for oil pressure sending units and switches, including universal and make-specific sizes. PVS TVS holds sockets for ported and thermal vacuum switches found on older engines.
Using them
Oxygen sensors often seize in the exhaust. Working on a warm, not hot, exhaust and using penetrating oil helps, and a 6-point socket that fits the hex fully is less likely to round it off. Route the wire through the slot before seating the socket so it is not pinched. On installation, follow the sensor maker instructions for thread compound and tightening.
Brands here include OTC, Kent-Moore, Lisle, Lang, GearWrench and Astro. Other engine tools, such as timing tools and compression testers, are in the neighboring Engine Repair Tools categories.



















Follow us on social media