Cylinder Hones and Stones
A hone puts a fresh finish on the inside of a cylinder bore. It removes glaze and light scoring and leaves a crosshatch pattern that holds oil and lets new piston rings or seals seat. This category includes flexible ball hones such as Flex-Hone tools in many diameters and grits, adjustable stone hones with replacement honing stones, brake cylinder hones and valve guide hone kits. Engine rebuilders, machine shops, auto repair technicians, small engine and marine shops and hydraulic repair shops use them during engine, brake and cylinder rebuilds.
Choosing the right type
Flexible ball hones have abrasive globules on flexible filaments. They follow the bore and are used mainly for deglazing and finishing, and each one is sized to a bore diameter, so choose the hone to match the bore. Adjustable stone hones carry two or three abrasive stones on spring-loaded arms that cover a range of bore sizes and can correct small amounts of taper when used with care. Brake cylinder hones are small hones for wheel cylinders and master cylinder bores, and valve guide kits finish small bores in heads and transmission valve bodies.
Grit and abrasive
Coarser grits cut faster and suit cleanup, while finer grits leave a smoother finish. Product names list the grit and abrasive, such as silicon carbide, so match them to the bore material and the finish the ring or seal maker calls for.
Using them
Drive the hone with a drill at moderate speed, use plenty of honing oil and keep the hone moving up and down the full bore at a steady rate to form an even crosshatch. Do not start or stop the drill with a ball hone outside the bore. Clean the bore thoroughly with hot soapy water afterward to remove abrasive. Ring compressors, ridge reamers and ring groove cleaners are in the sibling categories under Cylinder Tools.
Brands we carry
Hones and stones here come from Brush Research, Lisle, Cal-Van, CTA and OTC.
















































Follow us on social media