C-Clamps and Work Clamps
Clamps hold parts together, or hold work down, while you weld, drill, glue, cut or assemble. This category covers C-clamps and other screw clamps, bar and trigger clamps, and replacement clamp parts such as handles. Welders, fabricators, machinists, body shops, woodworkers, maintenance crews and home shops use them every day as an extra set of hands, and most shops end up with several sizes of each type.
Choosing a clamp
C-clamps have a fixed C-shaped frame and a threaded screw with a swivel pad at the end. They give strong, steady pressure and suit welding and metalwork, where a heavy frame shrugs off heat and spatter. Throat depth sets how far in from the edge of the work the clamp can reach, and the opening sets the thickest stack it can hold, so check both against the job. Screw clamps with a sliding arm on a bar, often called F-clamps or bar clamps, adjust quickly over a wide range and then tighten with a handle. Trigger clamps close with one hand by squeezing a trigger, which makes them quick for setups and lighter holding in assembly and woodwork while the other hand positions the part.
Using clamps
Spread the load with pads or scrap blocks on soft or finished surfaces, and tighten by hand rather than with a cheater bar, since too much force can bend a frame or mark the work. Place clamps close to the joint, and use more than one on long parts so the pressure is even. Keep threads clean and lightly oiled, and replace bent screws, cracked frames and worn pads; handles and other service parts are listed here for several clamp lines. When welding, keep spatter off the screw threads so they keep turning freely. For bench work, the Vises category gives a fixed hold, while clamps carry the hold to wherever the work is.
Brands we carry here include Kukko, Wilton, Wright, Bahco, Gedore and Proto.






















































Follow us on social media