Feeler Blades and Feeler Gauges
Feeler blades are thin strips of steel or brass ground to exact thicknesses. Slipped into a gap, they show how much clearance there is between two parts, such as valve lash, spark plug gaps, bearing and gear clearances, and brake and clutch adjustments. This category holds complete feeler gauge sets, single replacement blades, stepped go-no-go blades for quick pass or fail checks, and offset or long blades for reaching tight spots. Engine builders, diesel and fleet shops adjusting valves, small engine shops, machinists and maintenance technicians rely on them for accurate setup work.
Choosing the right type
A feeler gauge set fans a range of blade thicknesses on one holder, marked in thousandths of an inch, millimeters or both. Pick a set that covers the specifications you work with most. Long blades reach deep into engines and housings, and offset or angled blades fit between rocker arms and valve stems where a straight blade cannot. Brass blades are non-magnetic, which matters near magnetic parts such as some ignition pickups. Single replacement blades let a shop replace a worn or kinked size without buying a full set.
Go-no-go blades
A go-no-go blade is stepped: the thin tip should slide into the gap and the thicker section should not. That gives a fast pass or fail check, which suits valve lash adjustment on engines that list a minimum and maximum clearance.
Using feeler blades
Wipe the blade clean and slide it through the gap: the right thickness moves with a light, even drag. A blade that has to be forced is too thick, and one that falls through is too thin. Keep blades flat and lightly oiled, and replace any that are bent or worn, since a damaged blade gives false readings.
Brands we carry here include Lang, Kastar, OTC, CTA, Williams and Proto. Other measuring tools are in the sibling categories Micrometers, Dial Indicators and Spark Plug Gappers.






































Follow us on social media