Quick Step Catalyst for Zolatone 20 Series, Half Pint - Zolatone

ZT-9251-000C Quick Step Catalyst is specifically formulated to use with Zolatone 20 Series multicolor products to enhance water and chemical resistance without sacrificing adhesion or impact resistance. Zolatone 20 Series with Quick Step Catalyst can be used over ferrous metals, nonferrous metals, fiberglass, plastics and woods. Use of appropriate surface preparation methods and primer(s) will be necessary. The use of this catalyst is optional, however highly recommended and is to be used only if higher performance of Zolatone 20 Series multicolor.

Mix Ratio

16:1 or 1/2 pint Catalyst to 1 gallon 20 Series

Application

Over properly prepped and primed surface; select the proper primer/sealer base color for the Zolatone finish color. Refer to the Zolatone 20 Series pages or the Quick Step Catalyst Technical Data Sheet. Use a pressure pot system with a conventional or HVLP spray gun with a fluid tip of .080 to .090 inch or 2.0 to 2.4 mm. Apply Zolatone in a two step process. Sheer coat followed by Pattern Coat. Sheer Coat: Spray gun 12 inches from surface with fluid needle valve nearly in the closed position. Conventional Gun Air Pressure: 50-60 psi. HVLP Gun Air Pressure: 40-50 psi. Pot/Fluid Pressure: 10 psi (assumes 2 Liter pressure pot is used). Please see the Zolatone 20 Series pages for more application and technical information.

Zolatone 9251-000C-HP Quick Step Catalyst for Zolatone 20 Series, Half Pint