Door Hinge Pins, Bushings and Hinge Pin Tools
A vehicle door hangs on two hinges, and each hinge turns on a steel pin running through bushings. After years of opening and closing, the pins and bushings wear, the door drops at the latch end, and it starts to rub the striker, slam hard or leave a gap at the weatherstrip. This category holds replacement door hinge pins, hinge bushings and pin and bushing kits, including sets for GM trucks, along with tools for pushing worn pins out and pressing new ones in. Collision repair and body shops, general auto repair technicians, fleet garages and restorers use them to fix a sagging door without replacing the whole hinge.
Choosing the right parts
Hinge pins and bushings are made to fit particular vehicles and hinge designs, so match the kit to the make, model and door position before ordering. A kit with both pins and bushings is usually the better buy, because a new pin in a worn bushing will soon sag again. Some hinges also use a clip or retainer that should be replaced with the pin.
Doing the repair
Support the door with a door jack or a helper before any pin comes out, since the door is heavy and can fall once the hinge is free. Work one hinge at a time so the door stays located. A hinge pin tool or a press-type remover pushes the old pin out with less risk of bending the hinge than a hammer and punch. After the new bushings and pins are in, check the door gap and latch engagement and adjust the striker if needed. Door aligners and door handle tools are in the Door and Mirror Tools category, and body clips are in Body Clips and Fasteners.
Brands we carry here include Auveco, W&E Sales and CTA.














































Follow us on social media