A/C Tubing Benders and Cutters
Air conditioning lines are made from small diameter tubing that has to be cut square and bent without kinks so fittings seal and refrigerant flows freely. This category holds tubing cutters, from mini cutters for tight engine bays to heavy duty cutters, along with spring style bender sets, lever benders and bender pliers in common tube sizes.
Getting a clean cut
Tighten the cutter wheel a little at a time as you turn it around the tube. Forcing the wheel deforms soft aluminum and copper tube and leaves an end that will not flare or seal well. Ream the burr from the inside and keep chips out of the line, since debris in an A/C system can block an orifice tube or expansion valve. Cap open lines so moisture stays out.
Bending without kinks
Spring benders support the tube wall through gentle curves and suit soft tubing. Lever benders give tighter, repeatable bends using a forming shoe sized to the tube, which matters when a new line has to follow the original route. Check the tube sizes a bender covers before buying.
A/C technicians, auto repair shops and HVAC service crews use these tools to repair or fabricate refrigerant lines, replace damaged sections and fit lines during system retrofits. Brands here include Mastercool, Williams, Milwaukee, S.U.R.&R., General Tools and Imperial. Tools for finishing the tube ends are in the A/C Flaring Tools category.



























































Follow us on social media