SAE Crowfoot Wrench Sets
A crowfoot wrench is a wrench head with a square drive hole instead of a handle, so it fits on a ratchet, extension or torque wrench. It reaches nuts and fittings where a socket cannot slide on, such as fuel, brake and hydraulic line fittings, or nuts behind manifolds and brackets. This category holds sets in SAE sizes: open end crowfoot sets, flare nut crowfoot sets in 3/8 in. drive, and jumbo sets in 1/2 in. drive for larger fasteners.
Open end or flare nut
Open end crowfoot wrenches slide onto a nut from the side and suit general fasteners. Flare nut crowfoot wrenches wrap around more of the fitting, often in a 12-point design, and leave only a small opening for the line, so they grip tube nuts on more sides and are less likely to round them. Jumbo sets cover large fasteners such as pump, steering and axle nuts.
Using a crowfoot with a torque wrench
A crowfoot set at a right angle to the torque wrench handle keeps the reading the same as the setting. Set straight out in line with the handle, it lengthens the wrench and changes the applied torque, so the setting must be corrected. Check the service data for the right method.
Auto and truck technicians, hydraulic and aviation mechanics and industrial maintenance crews use these sets. Brands here include Williams, Sunex, K Tool, V8 Tools, CTA and Wright Tool. Single crowfoot wrenches are in the SAE Individual Crowfoot Wrenches category.
























































Follow us on social media