DeVilbiss Spray Gun Service Parts
Spray guns and pressure feed equipment wear with use. Worn fluid tips, needles, packings and seals cause drips, leaks and an uneven spray pattern long before the gun body itself is worn out. This category holds service parts for DeVilbiss spray guns and related paint equipment, so a gun can be rebuilt and kept in service instead of replaced. Automotive refinishers, collision shops, industrial paint lines and finishing shops keep common parts on hand.
What is in this category
Parts include fluid tips with gaskets in several sizes, air caps, packing and packing nut kits, diaphragm and valve kits, quick disconnects, filter elements, and liners for pressure tanks. Some Binks parts for related equipment are here as well.
Matching parts to the gun
DeVilbiss parts are made for specific gun models and setups. The fluid tip, needle and air cap work together as a matched set, and the tip size shown in the part name, such as 1.1, sets how much material flows. Check the gun model and the part number on the old part or in the gun manual before ordering, and replace tip, needle and seal parts together when the pattern or flow changes.
Keeping a gun spraying well
Most spray problems trace back to dried material and worn seals. Clean the gun thoroughly after each use, avoid leaving the whole gun soaking in solvent, and replace packings when the needle starts to leak or stick. A rebuild kit usually costs less than a new gun and often brings back a clean, even pattern. Strain paint before it goes into the gun and change filter elements regularly so debris does not reach the tip and needle.
Most parts here are from DeVilbiss, with some from Binks. Spray guns themselves, nozzles and service parts for other gun makers have their own pages under Spray Guns.














































Follow us on social media