Air Filters, Regulators, Dryers and Lubricators
Compressed air leaving a shop compressor carries water, oil and dirt, and its pressure is often higher than a tool or spray gun needs. This category holds the parts that treat air on its way to the point of use: filters, regulators, dryers, lubricators, combination units, and replacement bowls, elements and cartridges. Auto repair shops, body and paint shops, tire shops and industrial maintenance crews use them on their air lines.
What each part does
Particulate filters trap dirt, rust and liquid water, and coalescing or micro filters remove fine oil mist. Regulators set the working pressure at a drop or tool, so each tool runs at the pressure it was made for. Dryers, including desiccant units with replaceable cartridges, pull moisture out of the air before it reaches paint work or sensitive tools. In-line lubricators add a fine mist of oil for air tools that need it.
Setting up an air line
The usual order is filter first, then regulator, then lubricator. Lines that feed spray guns or paint booths should skip the lubricator, since oil in the air causes paint defects, and many paint shops add a desiccant dryer or micro filter close to the gun. Match the port size, such as 1/4 in. or 1 in. NPT shown in product names, and the flow rating to the tools on that line, so the unit does not starve the tool of air.
Maintenance
Drain filter bowls regularly, replace elements and desiccant when they are spent, and keep lubricators filled with air tool oil. A clogged element causes a pressure drop that can look like a weak tool. Check the regulator gauge from time to time to make sure the line still holds the set pressure.
Brands we carry here include Motor Guard, Milton, DeVilbiss, RTI, Ingersoll Rand and Arrow Pneumatics.
























































Follow us on social media