Heli-Coil Thread Repair
When the threads in a hole strip out, a Heli-Coil insert gives the hole new threads in the original size. The insert is a precision coil of wire with a diamond-shaped cross section. It winds into a slightly larger tapped hole and forms new internal threads that accept the original bolt. This category holds Heli-Coil thread repair kits, bulk inserts, the special taps and drills sized for them, and installation and tang break-off tools, in both SAE sizes such as 9/16-12 and 1-8 and metric sizes such as M8 x 1.25. Auto repair technicians, engine builders, small engine and equipment shops, machinists and maintenance crews use them, especially in soft metals like aluminum heads and housings.
How a repair is done
The stripped hole is drilled out with the drill size the kit calls for, then threaded with the matching Heli-Coil tap, which cuts a larger thread made for the insert. The insert goes on the installation tool and is wound into the hole until it sits just below the surface. On tanged inserts, a break-off tool then snaps the drive tang free. The finished hole takes the original bolt size and thread pitch.
Choosing kits and parts
A kit is the simplest start, because it holds the drill or tap, the installation tool and a supply of inserts for one thread size. Shops that repair the same sizes often buy bulk inserts in packs and separate installation tools. Match the insert to the bolt size, thread pitch and the insert length the job needs, and note whether the product is a standard or stainless insert. Clean chips and oil from the tapped hole before installing the insert. Thread files, chasers and other repair systems are in the Thread Repair category, and standard taps are in Taps and Dies.
Everything here is from Heli-Coil.








































Follow us on social media