Tool Tethering Products for Work at Height
A dropped tool is a hazard to people below and is often a lost or damaged tool. This category holds the parts of a tool tethering system: web strap tethers with snap hooks, clamps that anchor a tether to a structure, attachment clips and rings that go on the tool, and related accessories.
How a tethering system works
Each tool gets an attachment point, such as a clip or ring fitted to the handle. A tether links that point to an anchor, either on the worker or on a clamp fixed to the structure. If the tool slips, the tether catches it before it falls. Heavier tools are usually anchored to the structure rather than to the worker, so a falling tool does not pull the worker off balance.
What to look at when choosing
Match each tether, clip and clamp to the weight of the tool it will carry, as marked by its maker, and use snap hooks that close fully. Check straps, clips and clamps for wear before each shift and replace damaged parts.
Industrial maintenance crews, utility, wind and telecom workers, scaffold and construction crews and anyone working from lifts, ladders or platforms above others use tool tethering. The products here are from Williams. Tools made ready for tethering are in at Height Wrenches, at Height Sockets and at Height Tool Storage.























Follow us on social media