Stud Welders for Collision Repair
A stud welder, also called a dent spotter, welds small pins or studs onto the outside of a damaged panel so the dent can be pulled from the front. That saves drilling holes or removing inner panels and trim to reach the back of the dent. Collision repair shops, body shops and restoration builders use them on door dings, quarter panel creases and other sheet metal damage.
How stud welding works
The welder sends a short burst of current through a stud held in the gun tip, which fuses the stud to the bare metal. A slide hammer or a pulling tool then grips the stud and draws the low spot out while the technician works the high spots down. When the panel is straight, the studs are cut off and ground flush, and the area goes on to filler and paint. Paint and coatings have to be ground off at each spot first so the weld has clean metal to bond to.
Consumables and parts
Along with complete units and kits, this category carries what keeps a welder running: boxes of replacement studs, welding tips and collets, and service kits for pulling tools. Studs are used up on every job, so shops keep extra boxes in the sizes their gun takes. Check the product name for the welder model a part fits.
Brands we carry here include H&S Auto Shot, Motor Guard and Dent Fix. Slide hammers and pulling tools are nearby in Dent Pullers, Stud Pullers and Pulling Clamps under Pullers.







































Follow us on social media