Cordless Nibblers
A nibbler cuts sheet metal by punching out a series of small bites with a punch and die, leaving a narrow cut path. It can follow straight lines, curves and tight turns, and it does not heat the metal or throw sparks the way an abrasive cut-off wheel does, which helps limit distortion. Cordless models run on tool batteries, so there is no air hose or cord to manage.
Body shops, restoration and fabrication shops, HVAC and duct installers, and metal roofing and siding crews use nibblers to cut panels, flashing and ducting. Capacity is given in gauge, so check the model against the thickness of the metal. Accessories such as die holder extensions help reach into tight areas.
Our cordless nibblers are from Milwaukee on its M12 FUEL and M18 FUEL battery platforms. Cordless Shears and Cordless Saws, also in this section, offer other ways to cut sheet metal.
















Follow us on social media