Ingersoll Rand Service Parts
This category holds replacement and repair parts for Ingersoll Rand air tools and pumps. It includes bearings, throttle valve assemblies, diaphragms, valve and gasket kits and many other parts for IR impact wrenches, ratchets and other air tools. Parts for other makes of air and power tools are on the other pages in the Tool Service Parts section, including a General Service Parts page for mixed makes.
Ordering by model and part number
Every IR tool carries a model number, and its parts list gives each part a number. Look up the part on the drawing for your model and order by that number. Parts that look the same often differ between models, or between older and newer versions of the same tool, so check the listing against your model before ordering. When in doubt, compare the old part with the listing before installing the new one.
Rebuild or replace
A tool that has lost power, leaks air at the throttle or runs rough can often be brought back with fresh seals, bearings, valves and motor parts. On diaphragm pumps, the diaphragms and valve parts are the usual wear items. Replacing wear parts as a group during a rebuild saves taking the tool apart twice. Lubricate the tool as you reassemble it and oil it regularly once it is back in service.
Who uses them
Tool repair shops, fleet and diesel shops, plant maintenance departments and fluid handling crews use these parts to keep IR tools and pumps in service. Stocking a few common wear parts for the models your shop uses most keeps downtime short when a tool fails in the middle of a job. Keep the old parts until the rebuilt tool is tested, so you can compare them if something does not fit.
Nearly all parts here are listed under Ingersoll Rand, with a handful of related parts from Ajax and other air tool makers.








































Follow us on social media