Tubing Cutters
Tubing cutters clamp around a tube and roll a cutting wheel around it, tightening a little each turn until the tube parts with a clean, square end. Unlike a saw, a wheel cutter leaves no chips inside the line and no ragged edge, and a square cut is the first step before flaring or fitting a compression nut. This category holds cutters sized for brake line, fuel line and AC tubing.
Choosing a cutter
Mini cutters have a small body that turns in tight spaces, such as lines still on the vehicle near the frame or firewall. Standard and heavy duty cutters open wider and are easier to grip on bench work and larger tube. Ratcheting cutters let the user cut in short strokes where a full turn around the tube is not possible. Some product lines come in good, better and best versions; check the tube size range on the product before ordering.
Using them
Tighten the wheel only a little each turn; forcing it flattens the tube and makes a poor flare. After cutting, deburr the inside and outside of the end before flaring.
Brake and general repair technicians use them when replacing steel and other brake lines, AC and HVAC technicians use them on refrigerant lines, and fleet shops and restorers use them to make lines from bulk tubing.
Brands here include Mastercool, Robinair, Imperial, Ratch-Cut, BrakeQuip and GearWrench. To shape the line after cutting, see Tubing Benders.

























































Follow us on social media