Air Chisels and Air Hammer Bits
This category holds the bits and holding parts used in pneumatic air hammers, also called air chisels. The bits include flat and general service chisels, panel cutters, tie rod and ball joint separator bits, punches, drivers and other shaped tips, sold one at a time or in multi-piece sets. Quick change retainers and chucks that hold the bit in the hammer are here too. The hammers themselves are sold under Air Tools.
Choosing the right bit
Air hammer bits are made for a given shank size and retainer style, so the first check is that the bit matches your hammer. Several sets here are listed with a .498 shank, so check the shank on your hammer before ordering. Then pick the tip for the job: flat and general service chisels cut and split metal and shear off rusted fasteners, panel cutters slice sheet metal, separator bits drive apart tie rod ends and ball joints, and punches and drivers push out pins and bushings. Valve guide drivers and other shaped tips handle engine and machine work.
Retainers and good practice
A retainer holds the bit in the hammer so it cannot fly out when the tool is run. Quick change retainers let you swap bits without tools. Keep the bit pressed against the work before pulling the trigger, replace worn retainer springs and any bit with a mushroomed or cracked end, and wear eye protection, since chips and scale fly off fast.
Who uses them
Air hammer bits are used by auto repair and exhaust shops, body shops, fleet and diesel shops and fabricators for cutting metal, breaking rusted fasteners, separating front end parts and driving pins and bushings.
Brands we carry here include Ajax, Grey Pneumatic, S&G Tool Aid, Mayhew, K Tool and Astro Pneumatic. Air hoses, couplers and air tool oil are in the nearby air tool accessory categories.




















































Follow us on social media