Brake Caliper Tools
Every disc brake pad job means pushing the caliper piston back into its bore to make room for new pads. This category holds the tools for that and for the rest of caliper service: piston compressors, wind back tool sets, caliper adapters, caliper hangers and pad lining gauges. Auto repair shops, brake and tire shops, fleet garages and DIY mechanics use them.
Choosing the right type
Calipers with pistons that push straight back take a spreader or piston compressor, and some compressors work on several pistons at once. Many rear calipers with a built-in parking brake have pistons that must be turned while they are pushed. A wind back tool set does this with a group of adapter plates whose lugs or pins match the slots in the piston face. Check the adapters in a set against the vehicles you service.
Other caliper tools
Caliper hangers support a caliper off the knuckle or frame so it never hangs by its brake hose, which can damage the hose inside. Lining gauges measure remaining pad material so wear can be checked and recorded at every inspection. Caliper adapters fit tools to particular caliper and piston designs. Keeping these tools together on a cart or in one drawer saves time on a busy brake day, when the same few tools come out on every job.
Using them
Watch the fluid reservoir before pushing pistons back, since retracting them raises the fluid level. Push or turn the piston slowly and squarely to avoid damaging the seal or dust boot. On vehicles with electronic parking brakes, follow the service procedure or use a scan tool to put the system in service mode before retracting the piston. Bleeders and other brake tools are in Brake Bleeders and General Brake Service Tools.
Brands here include Lisle, OTC, CTA, Kent-Moore, Sunex and GearWrench.





























































Follow us on social media