Transmission and Line Disconnect Tools
Many vehicles join transmission oil cooler lines, fuel lines and other fluid lines with quick connect or spring-lock fittings instead of threaded nuts. These fittings hold the line with an internal spring or clip, and they will not come apart by pulling. A disconnect tool slides into the fitting to open that spring or clip so the line pulls free cleanly, instead of being pried, cut or bent.
Choosing the right tool
This category holds single disconnect tools sized by line diameter, multi-piece sets that cover several line sizes, and vehicle-specific tools made for certain makes. Some are for aluminum lines and some are made for fuel lines as well as cooler lines. Match the tool to the line size and fitting type; a tool that is too small will not release the spring, and one that is too large will not go in. Sets are the best choice for a general shop that sees many makes.
Using them
Clean dirt and rust from the fitting first. Push the line in slightly, slide the tool into the fitting until it seats, then pull the line apart while holding the tool in. Catch fluid in a drain pan, and check the fitting seals and clips before reconnecting.
Transmission shops, general auto repair technicians and fleet shops use them during transmission, radiator and fuel system work. Brands here include Lisle, OTC, Mopar, CTA, Endeavor and Lang. Seal, clutch and bushing tools are in the sibling categories.




















































Follow us on social media