Taps, Dies and Tap and Die Sets
Taps cut internal threads in holes, and dies cut external threads on rods, bolts and studs. This category holds individual taps, including plug and bottoming taps, hex and round dies, and tap and die sets in fractional, machine screw and metric sizes, along with thread repair kits for restoring damaged threads. Thread repair inserts, Heli-Coil kits and stud extractors also have their own pages in this department.
Choosing the right tap or die
Start with the thread size and pitch. SAE threads are given as diameter and threads per inch, such as 3/8 in.-16 NC, and metric threads as diameter and pitch. Machine screw sizes use a number gauge, such as 8-32. A plug tap is the general purpose choice for through holes, and a bottoming tap finishes threads close to the bottom of a blind hole. Hex dies can be turned with a wrench or socket, which helps when cleaning up threads on parts still in place, while round dies fit a die stock.
Using them
Drill the correct tap drill size first, use cutting oil, and back the tap off regularly to break the chip. Go slowly in hard material, since a broken tap is hard to remove. When the threads on a stud or bolt are rusty or bruised, running a die of the same size over them cleans them up so the nut turns freely again.
Sets or singles
Tap and die sets give you the common sizes in one case, with a tap wrench and die stock, and suit general repair work. Individual taps and dies replace a broken or worn size, or cover a thread size the set does not include.
Auto repair technicians, machine and fabrication shops, industrial maintenance crews and DIY mechanics use taps and dies to repair stripped holes, chase rusted threads and make threaded parts. Brands we carry here include Hanson, Century Drill, Irwin, Lang, Auveco and Heli-Coil, along with KnKut and OTC.





















































Follow us on social media