A/C Flush Kits
A/C flush kits clean the inside of an air conditioning system by pushing a flushing solvent through the lines, condenser and evaporator to carry out old oil, sludge and metal debris. Flushing is common after a compressor failure, when retrofitting a system or when a system has been contaminated, so that debris left behind does not damage the new parts. Auto repair shops, A/C specialists, fleet and heavy equipment shops and HVAC technicians use them during A/C repairs.
Types of flush tools
A canister flush kit holds solvent in a pressurized tank and uses shop air to push it through a component, then blows the part dry. A flush gun is a hand-held unit that shoots solvent through a line or part in short bursts. Flush hoses and adapters connect the tool to the many fitting sizes and styles found on A/C lines. This category also carries cans and jugs of flush solvent made for A/C work.
Using them
Flushing is done with the refrigerant recovered and the system open, usually one part at a time and often against the normal flow so debris comes out the way it went in. Some parts, such as the compressor and the accumulator or receiver drier, are normally replaced rather than flushed, so follow the service information for the system. Blow every flushed part dry so no solvent is left behind before the system is put back together.
Brands here include Mastercool, Robinair, FJC, CPS, Cliplight and Uview. Recovery machines are in A/C Recycling And Recharging and gauges are in A/C Manifold Gauges under Auto Air Conditioning Tools.






















































Follow us on social media