Differential Service Tools
Differential and axle work calls for tools a general toolbox does not have, and this category gathers them: pinion locknut sockets for removing and installing the nut on the pinion yoke, differential side bearing pullers, and adjusting tools used when setting up the gears. Many are factory-pattern tools for a particular car or truck maker, while others, such as truck pinion locknut socket sets, cover a range of axles.
How the tools are used
Side bearings are pressed onto the differential carrier, so a puller with jaws that reach behind the bearing is used to draw them off without damaging the case. Pinion locknuts sit deep in the yoke and need a socket shaped to clear it, often used with a holder that keeps the yoke from turning. During reassembly, adjusting tools help set bearing preload and ring and pinion backlash to the figures in the service manual.
Choosing the right tool
Start with the axle or vehicle application, then check puller reach and jaw size against the bearing, and socket size and drive against the pinion nut. Dealer-pattern tools are often called out by tool number in the service information, which makes matching straightforward.
These tools are used by drivetrain and transmission shops, dealership technicians and fleet and truck shops. Brands we carry here include OTC, Mopar, Assenmacher, Kent-Moore and Sunex. Seal tools are in Seal Removal & Installation, and yoke and joint tools are in Drive Shaft & U Joint.

















































Follow us on social media