Bearing and Bushing Pullers and Installers
Bearings and bushings are pressed into housings and hubs and onto shafts, so removing or fitting them takes a puller or press tool that applies force evenly. This category holds bearing pullers, internal and blind hole bearing pullers, bushing press frames, installer sets and replacement puller parts such as traverses and thrust bearings. Auto repair technicians, truck, fleet and diesel shops, and industrial maintenance crews working on motors, pumps and shafts all use them.
Choosing the right type
External pullers use jaws or a split separator plate behind a bearing to draw it off a shaft. Internal pullers expand inside the bore of a bearing to pull it from a housing, and blind hole pullers do the same where there is no access from behind, usually with a slide hammer or a counter support. Bushing press frames and installer sets use a threaded spindle and matched cups to push rubber suspension bushings, silent blocks and bearings in and out of control arms and knuckles, often without removing the part from the vehicle.
Sizing and setup
Pick a puller by its reach and spread, meaning the depth and diameter it can grip, and for internal pullers by the bore size range. For press work, choose adapters that bear on the outer race when pressing into a housing and on the inner race when pressing onto a shaft, so force does not pass through the balls or rollers. Some kits are made for particular vehicles, and their product names say which.
Using them
Keep the puller square to the shaft, tighten in steady turns, and lubricate the forcing screw and thrust bearing. Do not add leverage beyond what the tool is made for, and wear eye protection, since parts can release suddenly.
Brands we carry here include OTC, Kukko, Gedore, Tiger Tool, Sunex and Kent-Moore.


















































Follow us on social media