Free shipping on orders overFree shipping over $250 Lower 48 states and DC. Excludes freight and oversize.

Bearing/Bushing Puller - Blind Hole - Assenmacher Specialty Tools

Part #: 6100A

  • This set has a range of 12mm-16.5mm I.D.
  • Includes case.
    1. Select correct sleeve and mandrel combination (largest combination that will fit in bearing).
    2. Insert combination into crankshaft pilot bushing/bearing.
    3. Turn large knurled knob to expand sleeve inside bushing/bearing until finger tight.
    4. Place puller housing over mandrel.
    5. Thread black hex nut onto mandrel by hand, until snug against back of housing.
    6. While holding mandrel with 8mm wrench, turn black hex nut with 19mm wrench, until bushing/bearing is removed.

    Other Products You Might Search For

    (image for) Assenmacher Specialty Tools
    (image for) SLEEVE*
    $1.79
    Automatically suggested from the same category. Not a guaranteed match.
    (image for) Assenmacher Specialty Tools
    (image for) NUT*NLA
    $14.29
    Automatically suggested from the same category. Not a guaranteed match.
    (image for) OTC Tools and Equipment
    (image for) Blind Hole & Pilot Bearing Puller Kit
    $801.77
    Automatically suggested from the same category. Not a guaranteed match.
    (image for) Sir Tools
    (image for) Blind Hole Bearing / Bushing Collet Set w/ Slide Hammer - 8-Pc
    $294.06
    Automatically suggested from the same category. Not a guaranteed match.
    (image for) Sir Tools
    (image for) 17mm Collet
    $50.03
    Automatically suggested from the same category. Not a guaranteed match.
    (image for) Cal-van Tools
    (image for) Blind Hole Puller
    $357.50
    Automatically suggested from the same category. Not a guaranteed match.
    Tiger Tool Stud Install Anvil
    $57.90
    Automatically suggested from the same category. Not a guaranteed match.
    ADAPTER 5/8 - 18 LEFT*
    $62.45
    Automatically suggested from the same category. Not a guaranteed match.
    36mm 3/8" Drive Oil Filter Cap Wrench
    $27.04
    Automatically suggested from the same category. Not a guaranteed match.
    pilot bearing puller
    $30.97
    Automatically suggested from the same category. Not a guaranteed match.
    1/2" 1/2" Drive Stud Remover/Installer
    $21.43
    Automatically suggested from the same category. Not a guaranteed match.

    This product was added to our catalog on Thursday 01 February, 2007.