Menu

Bearing/Bushing Puller - Blind Hole - Assenmacher Specialty Tools

Part #: 6100A

  • This set has a range of 12mm-16.5mm I.D.
  • Includes case.
    1. Select correct sleeve and mandrel combination (largest combination that will fit in bearing).
    2. Insert combination into crankshaft pilot bushing/bearing.
    3. Turn large knurled knob to expand sleeve inside bushing/bearing until finger tight.
    4. Place puller housing over mandrel.
    5. Thread black hex nut onto mandrel by hand, until snug against back of housing.
    6. While holding mandrel with 8mm wrench, turn black hex nut with 19mm wrench, until bushing/bearing is removed.

    Recommended Alternatives

    This product was added to our catalog on Thursday 01 February, 2007.