Torsion Bar Saver W123, W126 S-Class

Mercedes S-Class W123 and W126 chassis are prone to failure of the torsion bar end. Over time the torsion bar end gets rusty and eventually the thinner part of the bar will break off rendering the vehicle unsafe to drive. Currently the only way to fix this is to replace the entire torsion bar, which is a major undertaking requiring approximately 20 hours. Most customers are unwilling to spend the money to make the repair.

With this kit the torsion bar can remain on the vehicle and the job takes about 1 hour (much less with experience).

  • First loosen the upper control arm mount on torsion bar.
  • Next remove the bolt, washer and rubber mount from torsion bar end.
  • Cut the torsion bar end off to approximately 1/2" back from the thin section.
  • Clean end and weld the Torsion Bar Saver in place.
  • Install upper control arm outer bushings and tighten.

The kit includes new bushings, washers. bolt and special stainless steel repair piece.

All returns on Baum Tools products have a 20% restock fee.

Baum Tools QP1000 Torsion Bar Saver W123, W126 S-Class

  • Model: 114415
  • Shipping Weight: 2.4lbs
  • Manufacturers Part #: QP1000
  • Manufactured by: Baum Tools
  • Also Known As: QP1000

Usually In Stock
Usually ships in 24-48 hours
Manufacturer Direct

$133.74

Add to Cart:

Current Reviews: 1

This product was added to our catalog on Wednesday 27 October, 2010.

Customers who bought this product also purchased...