Motor Magazine 2008 Top 20 Tools WinnerEliminate unnecessary component replacement and the inaccurate method of static voltage testing vehicle wiring with a DVOM. The Circuit Load Simulator is like using a KNOWN GOOD component to dynamically LOAD TEST the circuit.
Four Easy Steps to Test a Circuit- Disconnect the suspect component and connect the simulator to the vehicle connector.
- Select the type of load to simulate and press START.
- Activate the test circuit, in seconds the unit dynamically load tests power and ground wiring.
- View the results: "good", "bad" or "suspect", the measured voltage drop and "loaded ohms" reading.
Safe for computer controlled circuits.You can use the simulator to test the following circuits and more:
- fuel pump
- engine cooling fan
- windshield wiper
- power window
- power door lock
- HVAC blower
- side mirrors
- sun / moon roof
- 4x4 actuator
- low beam headlamp
- high beam headlamp
- brake / park lamps
- HID ballast
- AC clutch
- rear window defogger
- accessory port (cigar lighter)
- horn
- glow plug (single)
- heated seat
Waekon 44065 Circuit Load Simulator
Follow us on social media